钕玻璃的温敏特性及光纤温度传感器

本文从理论上通过对钕玻璃中Nd～(3+)离子光吸收特性的分析,阐明了其光吸收对温度依从性的原因.在实验中,试制了几种不同类型的钕玻璃光纤温度传感探头.对Nd～(3+)离子光吸收的温度特性进行了验证,其结果和理论分析相一致,实验表明钕玻璃是一种性能良好的光纤温敏传感材料.     

n—型聚乙炔复合膜电极性能的研究

自MacDiarmid等将聚乙炔(PA)做为二次电池的电极材料以来,其电化学特性和行为引起了人们的极大兴趣.随后的研究表明,p-型PA[(CH)~(y )Ay~-]_x在电解液中不稳定,用ClO_4~-掺杂的PA充放循环时有降解发生.n-型PA[My~ (CH)~(y-)]_x(y≤0.10)在THF/LiClO_4电解质中较稳定,电化学还原完全可逆,目前已实现1100次充放循环.因此,它既可做电池的正极材料(碱金属为负极),又可做负极材料(TiS_2为正极).我们发现     

Determination of dynamic properties of flax fibres reinforced laminate using vibration measurements

Experimental and numerical methods to identify the linear viscoelastic properties of flax fibre reinforced polymer (FFRP) composite are presented in this study. The method relies on the evolution of storage modulus and loss factor as observed through the frequency response. Free-free symmetrically guided beams were excited in the dynamic range of 10 Hz to 4 kHz with a swept sine excitation focused around their first modes. A fractional derivative Zener model has been identified to predict the complex moduli. A modified ply constitutive law has been then implemented in a classical laminates theory calculation (CLT) routine. Overall, the Zener model fitted the experimental results well. The storage modulus was not frequency dependant, while the loss factor increased with frequency and reached a maximum value for a fibre orientation of 70°. The damping of FFRP was, respectively, 5 and 2 times higher than for equivalent carbon and glass fibres reinforced epoxy composites.     

Double telecom band thermo-optic switch based on dual-line filled photonic liquid crystal fibres

We demonstrate a thermo-optic switch based on photonic liquid crystal fibres (PLCFs) in which two lines of air hole are selective filled with liquid crystal (LC), with a high extinction ratio of more than 20 dB around 1310 nm and 1550 nm. Only in the range of 2.0°C it can perform a turn off and on operation of transmitted light in the second telecom band around 1550 nm while the first telecom bands around 1310 nm is still on. Due to the splitting of the bandgap, the switching function is achieved in this kind of PLCFs. Before the cleaning point (CP) of LC, a broad bandgap from about 1120 nm to 1320 nm splits into two ones, which are continuing inducing huge bandgap extension to shorter wavelength and longer wavelength after the CP of LC, respectively. Moreover, the temperature responses around the CP of LC is also investigated. Its sensitivity is about ?92.32 nm/°C around the CP of LC. Therefore, such kind of selective-filled PLCFs could find potential applications as thermo-optic switch and temperature sensor in the telecom band.     

Effect of the preparation conditions on the formation of asymmetric poly(vinylidene fluoride) hollow fibre membranes with a dense skin

Integrally skinned asymmetric poly(vinylidene fluoride) hollow fibre membranes were prepared and characterized. The effects of phase inversion methods (dry-wet or wet) and spinning conditions, such as the type of solvent (NMP, DMAc), the concentration of polymer in dope solution, temperature of the external coagulation bath and the composition of the inner coagulant on the morphology and on the formation of a dense skin layer were investigated. The structure of the membranes was analyzed by scanning electron microscopy and the gas permeation properties with six different gases (He, H₂, N₂, O₂, CH₄ and CO₂) were measured at 25 °C to confirm the integrity of the selective skin layer. Under the proper conditions highly selective and permeable PVDF hollow fibre membranes were thus obtained by dry-wet spinning of a 30 wt.% PVDF solution in DMAc, using hot water (50 °C) as the external coagulant and a bore fluid of pure water as the internal coagulant. The best membrane had a selective outer skin with an effective thickness of approximately 0.2 μm. The ideal selectivity of the hollow fibres approached or even exceeded the intrinsic ideal selectivity of a dense PVDF film, for instance the selectivity for He over N₂ was 86.2 for the hollow fibre, whereas it was 83.5 for a dense PVDF reference film. DSC and FT-IR/ATR analysis indicated a higher fraction of the β-crystal phase in the selective skin and a high overall crystallinity than in the melt-processed film. The latter explains the relatively high selectivity and low permeability of the membranes. Intrinsic polymer properties make the membranes also suitable for vapour transport than for gas separation.     

Influence of accelerated ageing on the physico-mechanical properties of alkali-treated industrial hemp fibre reinforced poly(lactic acid) (PLA) composites

30 wt% aligned untreated long hemp fibre/PLA (AUL) and aligned alkali treated long hemp fibre/PLA (AAL) composites were produced by film stacking and subjected to accelerated ageing. Accelerated ageing was carried out using UV irradiation and water spray at 50 °C for four different time intervals (250, 500, 750 and 1000 h). After accelerated ageing, tensile strength (TS), flexural strength, Young's modulus (YM), flexural modulus and mode I fracture toughness (K_Ic) were found to decrease and impact strength (IS) was found to increase for both AUL and AAL composites. AUL composites had greatest overall reduction in mechanical properties than that for AAL composites upon exposure to accelerated ageing environment. FTIR analysis and crystallinity contents of the accelerated aged composites support the results of the deterioration of mechanical properties upon exposure to accelerated ageing environment.     

Emulator with inverse trend in first-order and second-order polarisation mode dispersion

We design a polarisation mode dispersion (PMD) emulator through subdividing a polarisation maintaining fibre (PMF) of 22 m in length. The aim of this emulator design is to show that first-order and second-order PMD can be inversely proportional to each other. Furthermore, the emulator is also used to show that the magnitude of PMD is independent to whether its statistics approach theoretical distributions or not, of most importance is the degree of mode coupling. The same (as former) applies to its autocorrelation function (ACF). The PMD control mechanism for the emulator is not in real time.     

Atomic NOON state generation in distant cavities by virtual excitations

A general scheme of generating NOON states of virtually-excited 2N atoms is proposed. The two cavities are fibre-connected with N atoms in each cavity. Although we focus on the case of N = 2, the system can be extended to a few atoms with N 〉2. It is found that all 2N atoms can be entangled in the form of NOON states if the atoms in the first cavity are initially in the excited states and atoms in the second cavity are all in the ground states. The feasibility of the scheme is carefully discussed, it shows that the NOON state with a few atoms can be generated with good fidelity and the scheme is feasible in experiment.     

Atomic N00N state generation in distant cavities by virtual excitations

A general scheme of generating N00N states of virtually-excited 2N atoms is proposed. The two cavities are fibre-connected with N atoms in each cavity. Although we focus on the case of N=2, the system can be extended to a few atoms with N>2. It is found that all 2N atoms can be entangled in the form of N00N states if the atoms in the first cavity are initially in the excited states and atoms in the second cavity are all in the ground states. The feasibility of the scheme is carefully discussed, it shows that the N00N state with a few atoms can be generated with good fidelity and the scheme is feasible in experiment.     

Globalizing weak homotopy equivalences

We generalize the basic quasifibration theorem of Dold and Thom (1958), replacing quasifibrations by weak equivalences.